User manual

16 | Chapter 1. Hardware Setup
N150 Wireless ADSL2+ Modem Router DGN1000 User Manual
3. Connect the Ethernet cable (C) from a wireless modem router LAN port to the Ethernet
adapter (D) in your computer
D
C
D
.
Figure 9. Connect the Ethernet cable to your computer
4. Plug the power adapter into the AC power adapter input (labeled Power ), and plug the other
end into a power outlet.
5. Connect any additional wired PCs to your router by inserting an Ethernet cable from a PC
into one of the three remaining LAN ports.
Verify the Cabling
Verify that your router is cabled correctly by checking the wireless modem router LEDs. Turn
on the wireless router by pressing the On/Off button on the back.
• The Power LED is green when the modem router is turned on.
•
The LAN ports are green for each PC cabled to the router by an Ethernet cable.
•
The wireless LED is green when the modem router is turned on.
•
The DSL LED is green when you have a DSL connection.
•
The Internet LED is red when there is no Internet connection.
Turn on your computer. If software usually logs you in to your Internet connection, do not run
that software. Cancel it if it starts automatically.
Verify that the LAN
lights (1 through 4) are lit for any computers cabled to the modem
router by an Ethernet cable.