User's Manual

S-Series OmniCell@Home Picocell GSM Implementation Guide Introduction
998-1027-01 Rev X2
1.2 Document Scope
This document covers installation and configuration of the OmniCell@Home base-
transceiver station, often referred to as Customer-Premise Equipment (CPE). The
Network Elements (NEs) are addressed in other documents in the OmniCell@Home S-
Series System Document Set as follows:
• <<To Be Supplied>>
1.3 General Safety Information
Read all the notices in this section prior to installing or using the S-Series system or any
of its components.
1.3.1 Confirmation of Conformance to National Regulation
The S-Series equipment complies with the provisions of the European R&TTE Directive
(99/05/EC). Declaration of conformity may be obtained from RadioFrame; Compliance
Engineering Department; 9461 Willows Road NE, Suite 100; Redmond, WA 98052, USA.
1.3.2 Static Sensitive Precautions
Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry. It
occurs when electronic printed circuit cards are improperly handled and can result in
complete or intermittent failures.
• Prior to handling, shipping, and servicing equipment, always put on a conductive
wrist strap connected to a grounding device to discharge any accumulated static
charges. All RFN FRUs ship with a disposable anti-static wrist strap.
Warning!
Use extreme caution when wearing a conductive wrist strap near sources of high
voltage. The low impedance provided by the wrist strap also increases the danger
of lethal shock should accidental contact with high voltage sources occur.
• Place FRUs only on an anti-static mat when removed from the system. The
conductive surface must be connected to ground through 100 kΩ.
• Do not use non-conductive material for packaging FRUs for shipment or storage.
Wrap all FRUs with anti-static (conductive) material.
• If possible, retain all original packing material for future use.
1.3.3 Safety Warnings
Warning!
Ultimate disposal of this product should be handled according to all national laws
and regulations.
Warning!
The user is cautioned that changes or modifications made to the equipment that
are not expressly approved by the party responsible for compliance, could void
the user’s authority to operate the equipment.
RadioFrame Networks, Inc. SUPPLIER AND CUSTOMER INFORMATION 7