User's Manual
Table Of Contents
- 1 Introduction
- 2 System Description
- 3 Specifications
- 4 Installation
- 5 Scheduled and Unscheduled Maintenance
- 6 System Configuration Changes
Installation S-Series OmniCell@Home Picocell GSM Implementation Guide 998-1027-01 Rev X2
4.3.2 Bringing up the PicoBTS
Connect the provided AC power cable to the PicoBTS, and, using the correct adapter for
the country’s power receptacles, plug the cable into the wall receptacle. Within three
minutes, the PicoBTS registers and is ready for use.
CPE IP Address
PicoBTSs can be configured with a static IP address, or addresses can be assigned by
DHCP. To change settings on a PicoBTS, you can connect a PC to one of the LAN ports
on the PicoBTS and browse to 192.168.0.1.
The default username is admin, with password admin123
Refer to Figure 4. On the general setup page you can select either DHCP or static IP
address.
It is not critical what IP addresses the PicoBTSs receive as long as they do not clash with
anything else on the same network.
Figure 4 PicoBTS Router Configuration Page
22 CONFIDENTIAL AND PROPRIETARY RadioFrame Networks, Inc.