User's Manual

RadioFrame Networks, Inc. S-Series GSM/GPRS Radio Base Station 11
Host Name If your ISP asks for a host name, make one up and enter it here.
MTU
The MTU (Maximum Transmission Unit) setting specifies the largest packet
size permitted for network transmission.
Size
This is not editable if you leave MTU at its default.
The Setup Tab—DHCP Setup
From the setup tab, if you click the DHCP Server link in the left margin, you will see
the screen shown in Figure 7. These settings allow you to configure the S1 router’s
LAN-side Dynamic Host Configuration Protocol (DHCP) server function for devices
connected to the S1 LAN ports.
Figure 7 DHCP Server Setup
DHCP Server By default, the router is enabled as a local DHCP server. If you
already have one on your network, set the option to
Disable
. (If you disable DHCP,
assign a LAN-side static IP address to the S1.)
Starting IP Address This address must be larger than the S1 LAN IP address and
on the same subnet. By default the Starting IP address is 192.168.0.50.
Number of Clients This is the maximum number of devices you wish the router to
be able to assign addresses.
Client Lease Time This is the amount of time before the devices will automatically
be reassigned a dynamic IP address.
Show Config button Shows a table of Starting IP Address, Number of Clients,
Client Lease Time and a delete checkbox to clear.
Show Lease button Shows a table of Host Name, MAC Address, IP Address.
When you are done setting up DHCP, click the Submit Changes button.