User's Manual

11
2
Installing the RFS
The RadioFrame System is modular and simple to install using the Site Design
Specification (SDS). The SDS specifies the following:
• Location of each system component: NCU, ACUs, RFUs, and RadioBlades.
• Mounting type for each component: rack, wall, or ceiling.
• Cabling requirements, including maximum cabling lengths, existing
wiring/raceways that can be used, and terminations and connections
required.
• Locations of approved power sources for each NCU and ACU.
Identify the RFS Installation Locations
Refer to the Site Design Specification (SDS) to determine the installation location
of each component of the RFS. The NCU is typically installed in a
telecommunications room or other closet, ACUs are installed in a similar location
depending on the system layout, and each RFU is installed on a wall or on or
above a ceiling in open areas of the building. RadioBlades are inserted into each
RFU.