User's Manual

MC-Series Standard Capacity system

998-1019-01 Rev X1

Proprietary and Confidential Information

Note: For specifications, refer to section 2.4.2

(Transmitter Performance Summary). The default

is +33 dBm per carrier, assuming that the datafill

parameter defaultTxPower is set to 9.5. If

necessary, adjust the datafill parameter (refer to

section 5.3.5 (defaultTxPower)).

12. Measure the SQE and frequency error for the control channel to see if they are

within specifications.

13. Verify that all BRs have the same output power.

For each channel, enter the frequency into the R2660 and verify that the SQE,

frequency error, and power level are all within specifications (refer to Table

2.9).

14. Repeat steps 7 through 13 as needed for each sector.

15. Review the

Active Alarm Manager for any un-cleared alarms.

Refer to the section (System Manager Alarms) for more information.

5.3 Management—Datafill, Configuration and Optimization

This section describes configuration techniques that affect the behavior of the MCSC

system. The Datafill section covers the datafill parameters as they differ from the

Motorola EBTS. Section System Manager, Configuration, and Optimization covers

configuration options using System Manager, with sections Navigating System

Manager and Configuring the MC-Series Standard Capacity system introducing basic

operations and Optimization Procedures presenting optimization procedures.

The MCSC system is designed for compatibility with the Motorola EBRC and QUAD

Base Radios (BRs). However, due to architecture differences between the two

systems, not all datafill parameters apply equally to the MCSC system.

5.3.1 Datafill

This section describes only those datafill parameters that need to be taken into

consideration when used with the MCSC system. Any datafill parameter not

described here can be assumed to behave identically to the Motorola EBTS. This

section includes:

• 5.3.2 (Parameters that Do Not Apply) Parameters that have no effect on the

MCSC system

• 5.3.3 (Recommended Datafill Parameters) Parameters that RadioFrame

Networks supports, but which need to be setup differently from the typical

setup for a Motorola BR