User's Manual

MC-Series Standard Capacity system

998-1019-01 Rev X1

Proprietary and Confidential Information

Working near High Voltage Sources

The low impedance provided by the wrist strap also increases the danger

of lethal shock should accidental contact with high voltage sources occur.

Further Safety Recommendations

• Do not work alone if potentially hazardous conditions exist.

• Never assume that power is disconnected from a circuit--ALWAYS

check

• Look carefully for possible hazards in the work area, such as moist floors,

ungrounded extension cables, frayed power cords and missing safety

grounds

Refer to Appendix A (General Safety Information) for more detailed safety

instructions.

1.4 System Definition

The MCSC system is a stand-alone rack mount base transceiver station (BTS) that

provides radio communication links between the land network and mobile subscriber

units in an integrated Dispatch Enhanced Network (iDEN). The MCSC system

interfaces with the Mobile Switching Office (MSO) via a standard T1 or E1 interface.

This link also provides the Operations and Maintenance Center (OMC) with alarm

information, and enables the OMC to remotely control and configure system

operations via a standard site datafill.

Using an external, environmentally controlled enclosure, the MCSC system is a one

sector (with two additional sectors available via an expansion cabinet not covered in

this document).

MC-Series Standard Capacity system Field Replaceable Unit

Parts List

Table 1.1 contains current parts list for the MCSC system that are Field Replaceable

units (FRU).

Refer to section 9.1.1 (Field Replaceable Unit (FRU) Policy) or replacing any of the

following equipment. For equipment not supplied by RadioFrame Networks, follow

standard policies and procedures for FRU replacement.

Warning

Use extreme caution when wearing a conductive wrist strap near sources of high

voltage