Manualshelf

User's Manual

ManualsBrandsRadioFrame Networks ManualsElectronicsMC Series Standard Capacity Base Station
141142143144145146147148149150
MC-Series Standard Capacity system
998-1019-01 Rev X1
9-22 ©2008 RadioFrame Networks, Inc. MC-Series
Proprietary and Confidential Information
c. Gently lift and remove the RadioBlade transceiver from the slot in the
DRBS backplane.
d. Place the RadioBlade transceiver in anti-static packaging for shipment.
Figure 9.11 RadioBlade Transceiver in Place
4. Install the replacement RadioBlade.
a. Un-package the replacement RadioBlade transceiver to be inserted into
the DRBS.
b. Insert the RadioBlade transceiver into the specified slot in the DRBS
until the connector seats firmly into the backplane of the DRBS.
c. Connect the Rx cable to the Rx port (the BOTTOM connector on the
MCRB) and Tx cable to the Tx port (the TOP connector) on the MCRB.
d. Place the lock-down strap over the RadioBlade transceiver by inserting
the two feet on the strap into the slots on the DRBS backplane, and then
hand tighten the screw into place.
Important:
Verify the connections are correct! Tx is the TOP connector on the MCRB; Rx is
the BOTTOM connector on the MCRB.