User's Manual

MC-Series Standard Capacity system
998-1019-01 Rev X1
9-14 ©2008 RadioFrame Networks, Inc. MC-Series
Proprietary and Confidential Information
5. Place the old board in the antistatic packaging for shipment.
6. Using the breakers on the PDU, turn up the ABIC and DRBS and then verify
that the components are operational before proceeding.
a. Wait approximately 3 minutes for the following indicators:
DRBS:
• The STATUS LED for each group will turn green in this order: A and then
B, and finally C.
Note: Group “B” LED will only turn green if a second
sector (in the expansion cabinet (not covered in
this document)) has been configured.
Note: Group “C” LED will only turn green if a third
sector (in the expansion cabinet (not covered in
this document)) has been configured.
• The RADIOBLADE TRANSCEIVER STATUS LEDs will turn red and then
green for each present RadioBlade transceiver. If no RadioBlade
transceiver is present, the LED will not light. To verify the contents of the
DRBS, pull out the shelf (powering off is not required) and inspect the
RadioBlade transceivers and their respective status LEDs. Reinsert the
DRBS. To do this, press up on one side rail locking arm and press down
on the other side rail locking arm, and then push the unit into the cabinet.
For an illustration of the locking arms, refer to Figure 9.13.
ABIC CRIC
• The POWER and STATUS LEDs will turn red and then green. All other
ABIC card LEDs will turn green.
7. Using the breaker on the PDU, turn up each RF Shelf and then verify that each
RF Shelf is operational before proceeding.
The POWER and ALARM LEDs on the front of the RF Shelf will turn green.
8. FOR THE ABIC CRIC ONLY: complete the procedures in sections 5.2 (System
Setup) and Appendix C (Functionality Test Procedures).
9.5.2 BPC
1. Before replacing any card (board) in the ABIC, power down RadioFrame
Networks equipment in the following order using circuit breakers on the PDU:
•BIC
• DRBS
• RF Shelves