User's Manual

MC-Series Outdoor Pole Mount Users Guide

998-5005-01 Rev X1

CONFIDENTIAL AND PROPRIETARY

Figure 6.2 RF Shelf Mounting Screw Locations

4. Mount the replacement RF shelf.

While supporting the RF shelf, slide it into the Cabinet mounting position.

Secure the RF shelf to the Cabinet mounting rails using the four mounting

screws provided with the unit. Tighten the screws to 4.5 Nm (40 in-lb).

5. Reconnect the cabling to the replacement chassis.

Note: Use the SMA torque wrench for all SMA

connectors.

6. Using the breakers on the PDU, turn up the ABIC and DRBS and then verify

that the components are operational before proceeding.

7. Wait approximately 3 minutes for the following indicators:

DRBS:

• The STATUS LED for each group will turn green in this order: A and then

• The RADIOBLADE TRANSCEIVER STATUS LEDs will turn red and then

green for each present RadioBlade transceiver. If no RadioBlade

transceiver is present, the LED will not light. To verify the contents of the

DRBS, pull out the shelf (powering off is not required) and inspect the

RadioBlade transceivers and their respective status LEDs. Reinsert the

DRBS. To do this, press up on one side rail locking arm and press down

on the other side rail locking arm, and then push the unit into the Cabinet.

For an illustration of the locking arms, refer to Figure 6.13.

ABIC CRIC:

The POWER and STATUS LEDs will turn red and then green. All other ABIC

card LEDs will turn green.