User's Manual

MC-Series Outdoor Pole Mount Users Guide998-5005-01 Rev X1

CONFIDENTIAL AND PROPRIETARY

• One Ethernet port and one 9-pin serial port

• 6-foot Cat-5 (or 5e/6) Ethernet cable (EIA/TIA 568B) to connect to the ABIC

CRIC

• Straight-through, male-to-female serial cable (DB9/RS232)

• 50 ohm 2W terminating loads for all RF ports to be used according to the

site configuration

Ensure that the following RadioFrame Networks software is available:

• CD ROM (backup)

• New versions can also be downloaded from RadioFrame Networks web site

to the local root directory (C:/)

For local software downloads, have the following available on the laptop:

• FTP server software—WFTPD32 is shareware that can be downloaded

from the following site: http://www.wftpd.com/

• Terminal emulation software (e.g., PROCOM)

4.1.2 Checkout Procedures

1. Verify that all breakers in the PDU are in the OFF position prior to proceeding.

Leave them in the OFF position until instructed otherwise.

2. Conduct a visual inspection of the cabling on the rear of the Cabinet verifying

that all connections are in place, tight, and complete.

3. Add and remove RadioBlade transceivers according to the site configuration.

Refer to section 6.7 (RadioBlade Transceiver Replacement).

4. Verify that cabling matches the site configuration.

5. Refer to Appendix C (OPM iDEN Microcell Cabinet Stack-Up Configuration).

6. Install 50 ohm 2 W terminators on all unused Tx / Rx / Rx Diversity ports on the

rear of the enclosure.

7. Verify that there is DC power at the supply terminals on the PDU and that the

polarity is correct.

Caution!

Verify that all breakers in the PDU are in the OFF position prior to proceeding.

Leave them in the OFF position until instructed otherwise.