User's Manual

MC-Series Outdoor Pole Mount Users Guide

998-5005-01 Rev X1

CONFIDENTIAL AND PROPRIETARY

Note: The default is +36 dBm per carrier, assuming that

the datafill parameter defaultTxPower is set to

9.5. If necessary, adjust the datafill parameter

(refer to section 2.3.5 (defaultTxPower)).

12. Measure the SQE and frequency error for the control channel to see if they are

within specifications.

13. Verify that all BRs have the same output power.

For each channel, enter the frequency into the R2660 and verify that the SQE,

frequency error, and power level are all within specifications.

14. Repeat steps 7 through 13 as needed for each sector.

15. Review the Active Alarm Manager for any un-cleared alarms.

Refer to the section (System Manager Alarms) for more information.

2.3 Management—Datafill, Configuration and Optimization

This section describes configuration techniques that affect the behavior of the MC-

Series OPM system. The Datafill section covers the datafill parameters as they differ

from the Motorola EBTS. Section System Manager, Configuration, and Optimization

covers configuration options using System Manager, with sections Navigating

System Manager and Configuring the MC-Series OPM System introducing basic

operations and Optimization Procedures presenting optimization procedures.

The MC-Series OPM system is designed for compatibility with the Motorola EBRC

and QUAD Base Radios (BRs). However, due to architecture differences between

the two systems, not all datafill parameters apply equally to the MC-Series OPM

system.

2.3.1 Datafill

This section describes only those datafill parameters that need to be taken into

consideration when used with the MC-Series OPM system. Any datafill parameter

not described here can be assumed to behave identically to the Motorola EBTS.

This section includes:

• 2.3.2 (Parameters that Do Not Apply to the MC-Series OPM System)

Parameters that have no effect on the MC-Series OPM system

• 2.3.3 (Recommended Datafill Parameters) Parameters that RadioFrame

Networks supports, but which need to be setup differently from the typical

setup for a Motorola BR

2.3.2 Parameters that Do Not Apply to the MC-Series OPM System

The following parameters have no effect on the MC-Series OPM system. There is

no functional equivalent in the MC-Series OPM system, and as such the

parameters can be ignored.