User's Manual

MC-Series Outdoor Pole Mount Users Guide

998-5005-01 Rev X1

CONFIDENTIAL AND PROPRIETARY

Appendix G Dangerous RF Emissions Precautions

This equipment is designed to generate and radiate radio frequency (RF) energy by

means of an external antenna. When terminated into a non-radiating RF load, the

base station equipment is certified to comply with Federal Communications

Commission (FCC) regulations pertaining to human exposure to RF radiation in

accordance with the FCC Rules Part 1 section 1.1310 as published in title 47 code

of federal regulations and procedures established in TIA/EIA TSB92, Report on

EME Evaluation for RF Cabinet Emissions Under FCC MPE Guidelines,

Compliance to FCC regulations of the final installation should be assessed and take

into account site specific characteristics such as type and location of antennas, as

well as site accessibility of occupational personnel (controlled environment) and the

general public (uncontrolled environment). This equipment should only be installed

and maintained by trained technicians. Licensees of the FCC using this equipment

are responsible for insuring that its installation and operation comply with FCC

regulations Part 1 section 1.1310 as published in title 47 code of federal regulations.

Whether a given installation meets FCC limits for human exposure to radio

frequency radiation may depend not only on this equipment but also on whether the

“environments” being assessed are being affected by radio frequency fields from

other equipment, the effects of which may add to the level of exposure.

Accordingly, the overall exposure may be affected by radio frequency generating

facilities that exist at the time the licensee’s equipment is being installed or even by

equipment installed later. Therefore, the effects of any such facilities must be

considered in site selection and in determining whether a particular installation

Warning!

The MC-Series OPM System has been approved for antennas up to +20 dBi. At

energy levels within the approved range, operation may present hazards to life

and health.

RF emission level is a function of the installation. Accordingly, it is the

responsibility of the equipment owner, and not RadioFrame Networks, Inc., to

apply signage to the site if it is required under 47 CFR 1.1310.

Please carefully read and observe the following warnings!