User's Manual

CONFIDENTIAL AND PROPRIETARY

MC-Series Outdoor Pole Mount Users Guide

998-5005-01 Rev X1

b. If the only BER measurements reported are 50%, NO DATA, or both,

verify that all procedure steps have been completed. If no problems are

found, cycle power to the R2660 and set it up again to generate an in-

bound 1x6 test signal at the desired frequency and signal level into the

Rx port. It may take a few minutes for the R2660 test signal to stabilize.

If there's still no change after cycling power to the R2660, select the

Stop Test button.

12. When the BER test is complete, lock the RadioBlade transceiver that was

under test.

13. Display the RadioBlade Control page, and lock the RadioBlade transceiver

by selecting its lock icon so that it is closed (locked).

a. Refresh the page every 30 seconds until the State of the RadioBlade

transceiver has changed to ‘2’.

14. Repeat Steps 1 through 12 for each RadioBlade transceiver to be tested on

this Rx port.

15. Move the test leads to the next sector at TOR when all desired blades in the

current sector have been tested and repeat the procedure.

F.8 Equipment Disconnection

Note: Disconnect equipment after completing the BER

testing.

1. Disconnect the R2660 from the Rx port under test.

2. Display the DRBS Status page, and verify that all RadioBlade transceiver status

icons are green.

3. Disconnect the network cable from port 8 of the ABIC CRIC.

F.9 BER Test Notes Master

You can use this page to make copies of Table F.1 for use as a handy organizer and

permanent record of the BER tests.