User's Manual

MC-Series Outdoor Pole Mount Users Guide
998-5005-01 Rev X1
F-10 ©2007 RadioFrame Networks, Inc. MC-Series
CONFIDENTIAL AND PROPRIETARY
Figure F-6 Bit Error Rate Start Test Page
10. Verify that the displayed Rx Frequency matches the desired receive
frequency.
11. Approximately every second, the page reports the current BER
measurement (BER) and the running average of the ten latest BER
measurements (BER Avg). Record these results, and then select the Stop
Test button.
a. If the warning “Test Signal Timing Out of Lock” appears, cycle power to
the R2660 and set it up again to generate an in-bound 1x6 test signal at
the desired frequency and signal level into the Rx port. It may take a few
minutes for the R2660 test signal to stabilize.