User's Manual

MC-Series Outdoor Pole Mount Users Guide998-5005-01 Rev X1

CONFIDENTIAL AND PROPRIETARY

Figure 1.1 Locations of Non-RadioFrame Networks Hardware the OPM System Cabinet

1.1.1 iSCIII

Note: The iSCIII does not come pre-installed with the

OPM system. Therefore, follow this procedure to

install the component.

1. While supporting the iSCIII, slide the iSCIII into the Cabinet mounting position.

2. Mount the iSCIII in the location shown in Figure 1.1. If necessary, install side

rails in the mounting position in the Cabinet.

3. Secure the iSCIII to the Cabinet mounting rails using the four mounting screws

provided with the unit. Tighten the screws to 4.5 Nm (40 in-lb).

4. Connect the RadioFrame Networks-provided ground cable (P/N 820-0609-10;

ISC1 to GND BAR) between the Cabinet ground bar and the grounding lug on

the rear of the iSCIII, and ensure the connection is tight.