User's Manual

MC-Series Outdoor Pole Mount Users Guide
998-5005-01 Rev X1
A-2 ©2007 RadioFrame Networks, Inc. MC-Series
CONFIDENTIAL AND PROPRIETARY
A.2 Safety Warnings
A.3 Safety Warnings per Cabinet Mount Instructions
The following or similar Cabinet mount instructions are included with the installation
instructions:
Reduced Air Flow
Installation of the equipment in the Cabinet should be such that the amount of air
flow required for safe operation of the equipment is not compromised.
Warning!
Use extreme caution when wearing a conductive wrist strap near sources of high
voltage. The low impedance provided by the wrist strap also increases the danger
of lethal shock should accidental contact with high voltage sources occur.
Warning!
Ultimate disposal of this product should be handled according to all national laws
and regulations.
Warning!
The user is cautioned that changes or modifications made to the equipment that
are not expressly approved by the party responsible for compliance, could void
the user’s authority to operate the equipment.
Warning!
To ensure FCC compliance of this equipment, it is the user’s responsibility
to obtain and use only shielded and grounded interface cables.
Warning!
FCC RF Exposure Compliance: FCC RF exposure compliance must be
addressed at the time of licensing, as required by the responsible FCC Bureau(s),
including antenna co-location requirements of §1.1307(b)(3). The applicable
exposure limits, to demonstrate compliance, are specified in FCC Part 1.1310.
Additionally, the installer of the antenna to be used with this transmitter may be
required to perform an MPE evaluation and an Environmental Assessment (EA) of
the location at the time of licensing per CFR 47 Part 1.1307. Fixed mounted
antenna(s) that are co-located with other antenna(s) must satisfy the co-location
requirements of Part 1.1307 for satisfying RF exposure compliance