User's Manual

MC-Series Outdoor Pole Mount Users Guide998-5005-01 Rev X1

CONFIDENTIAL AND PROPRIETARY

c. Connect the Rx cable to the Rx port (the BOTTOM connector on the

MCRB) and Tx cable to the Tx port (the TOP connector) on the MCRB.

d. Place the lock-down strap over the RadioBlade transceiver by inserting

the two feet on the strap into the slots on the DRBS backplane, and then

hand tighten the screw into place.

Figure 6.12 Seating the RadioBlade Transceiver

5. Connect the Rx and Tx cables to the correct ports on the RadioBlade

transceiver, and use the SMA torque wrench to tighten.

6. Re-insert the DRBS into its chassis. To do this, press up on one side rail locking

arm and press down on the other side-rail locking arm, and then push the unit

into the Cabinet (see Figure 6.13).

Important:

Verify the connections are correct! Tx is the TOP connector on the MCRB; Rx is

the BOTTOM connector on the MCRB.