User's Manual

MC-Series Outdoor Pole Mount Users Guide

998-5005-01 Rev X1

CONFIDENTIAL AND PROPRIETARY

DRBS. To do this, press up on one side rail locking arm and press down

on the other side rail locking arm, and then push the unit into the Cabinet.

For an illustration of the locking arms, refer to Figure 6.13.

ABIC CRIC

• The POWER and STATUS LEDs will turn red and then green. All other

ABIC card LEDs will turn green.

7. Using the breaker on the PDU, turn up each RF Shelf and then verify that each

RF Shelf is operational before proceeding.

The POWER and ALARM LEDs on the front of the RF Shelf will turn green.

8. FOR THE ABIC CRIC ONLY: complete the procedures in sections 2.2 (System

Setup) and Appendix D (Functionality Test Procedures).

6.5.2 BPC

1. Before replacing any card (board) in the ABIC, power down RadioFrame

Networks equipment in the following order using circuit breakers on the PDU:

• ABIC

• DRBS

• RF Shelves

2. Always use a static grounding wrist strap before handling any board—do not

attach the wrist strap to any painted surface on the chassis unit.

3. Facing the chassis unit, remove the BPC that is to be replaced, or the blank

faceplate, following these guidelines:

a. Loosen the blue knurled knobs on both sides of the board.

b. Pull firmly on the tabs located on the bottom of the BPC you are

replacing.

c. Gently slide the BPC straight out and away from the chassis unit so as

not to damage any components contained on the board.

4. Remove the BPC from its antistatic packaging and insert it into the chassis unit

as shown in Figure 6.7, and follow these guidelines:

a. Do not jam the board in any way while inserting it.

b. Do not mount the board in any orientation other than that specified in the

diagram.

c. Insert the board straight into the chassis unit so as not to damage any

components contained on the board.

d. Press firmly to seat the board into the connectors within the chassis unit.