User's Manual

MC-Series Outdoor Pole Mount Users Guide998-5005-01 Rev X1

CONFIDENTIAL AND PROPRIETARY

b. Do not mount the board in any orientation other than that specified in the

diagram.

c. Insert the board straight into the chassis unit so as not to damage any

components contained on the board.

d. Press firmly to seat the board into the connectors within the chassis unit.

e. Tighten the blue knurled knobs on each end of the board finger tight

only—do not use a screwdriver to tighten the screws and do not over

tighten.

Figure 6.6 Replacing the CRIC

5. Place the old board in the antistatic packaging for shipment.

6. Using the breakers on the PDU, turn up the ABIC and DRBS and then verify

that the components are operational before proceeding.

a. Wait approximately 3 minutes for the following indicators:

DRBS:

• The STATUS LED for each group will turn green in this order: A and then

Note: Group “C” LED will only turn green if a second

sector (in the expansion cabinet) has been

configured.

• The RADIOBLADE TRANSCEIVER STATUS LEDs will turn red and then

green for each present RadioBlade transceiver. If no RadioBlade

transceiver is present, the LED will not light. To verify the contents of the

DRBS, pull out the shelf (powering off is not required) and inspect the

RadioBlade transceivers and their respective status LEDs. Reinsert the