User's Manual

MC-Series Outdoor Pole Mount Users Guide
998-5005-01 Rev X1
6-12 ©2007 RadioFrame Networks, Inc. MC-Series
CONFIDENTIAL AND PROPRIETARY
ABIC CRIC:
• The POWER and STATUS LEDs will turn red and then green. All other
ABIC card LEDs will turn green.
7. Using the breaker on the PDU, turn up each RF Shelf and then verify that each
RF Shelf is operational before proceeding.
The POWER and ALARM LEDs on the front of the RF Shelf will turn green.
8. Complete the procedures in sections 2.2 (System Setup) and Appendix D
(Functionality Test Procedures).
6.5 ABIC– FRU Replacement Procedure
6.5.1 Replacing the CRIC
1. Before replacing any card (board) in the ABIC, power down RadioFrame
Networks equipment in the following order using circuit breakers on the PDU:
• ABIC
• DRBS
• RF Shelf
2. Always use a static grounding wrist strap before handling any board—do not
attach the wrist strap to any painted surface on the chassis unit.
3. Facing the ABIC, remove the CRIC that is to be replaced, following these
guidelines:
a. Loosen the blue knurled knobs on both sides of the board.
b. Pull firmly on the tabs located on the bottom of the CRIC.
c. Gently slide the CRIC straight out and away from the chassis unit so as
not to damage any components contained on the board.
4. Remove the replacement CRIC from its antistatic packaging and insert it into
the chassis unit as shown in Figure 6.6, and follow these guidelines:
a. Do not jam the board in any way while inserting it.
IMPORTANT
BEFORE REPLACING ANY CARD (board) in the ABIC, power down the
RadioFrame Networks equipment in the following order using circuit breakers on
the PDU:
• ABIC
• DRBS
• RF Shelf