Installation Guide
Table Of Contents
- Title
- Contents
- Introduction
- System Description
- Pre-Installation
- Receipt of Equipment
- Site Planning
- Main Rack and Supporting Hardware
- Remote ACUs
- RFUs
- RadioBlades
- RAPs
- URU
- Interconnecting Cabling
- Main Rack Configuration
- RF Planning
- Site Survey
- Alarm Configuration
- Tools Required
- Installation
- Equipment Commissioning
- iDEN Interface
- Power Plant
- RadioFrame System
- Coverage Validation
- Site Acceptance Guidelines
- RadioFrame System Functionality Test
- RadioFrame System iDEN Functionality Test
- Interconnect & Dispatch Setup & Voice Quality
- Packet Data Service Connection and Latency
- Short Message Service
- Handover and Cell Reselection
- Interconnect Connection Stability and SQE Performance
- Dispatch Connection Stability
- Idle SQE Testing and Validation
- System Self-Recovery Test
- Packet Data Stability and Throughput
- Validation of ‘Unable to Key BR’ Alarm
- Rectifier & AC Power Alarms
- iSC-3 Functionality Test
- RadioFrame System iDEN Functionality Test
- Connecting the RFS to the Customer LAN
- Operations and Maintenance
- Appendixes
RadioFrame System
Equipment Commissioning
RFN_3.1 Beta 87
Status Indicator Description Action
Green Unit Installed and fully
functional
The component has been installed, configured,
and is operating as it should.
Yellow Unit installed but not
configured
Component has been installed and the System
Manager software is still configuring the
component. When System Manager has finished
startup (10 to 20 minutes), the status will turn to
green, unless there’s a problem with the unit.
Gray Unit not installed Component has not yet been installed.
Red Alarm condition The component has returned an alarm condition.
Refer to Section 7 “Operations and Maintenance”
for specific alarm conditions pertaining to the
component.
5.3.4 Configuring the NCU
The NCU System Configuration page displays the NCU Device Configuration,
including the Device Name, IP Address, and Building Address for the NCU—you
can change this information at any time. This page also displays the External IP
Configuration, the information that systems outside the RFS use to recognize
the RFS, the SNTP Server Configuration, and Other Configuration Options.
1 For Device Name, enter up to 31 alphanumeric characters to uniquely
identify the NCU.
2 The IP Address is assigned during the installation of the RFS. You don’t
need to change the value of this internal address.