Installation Guide
Table Of Contents
- Title
- Contents
- Introduction
- System Description
- Pre-Installation
- Receipt of Equipment
- Site Planning
- Main Rack and Supporting Hardware
- Remote ACUs
- RFUs
- RadioBlades
- RAPs
- URU
- Interconnecting Cabling
- Main Rack Configuration
- RF Planning
- Site Survey
- Alarm Configuration
- Tools Required
- Installation
- Equipment Commissioning
- iDEN Interface
- Power Plant
- RadioFrame System
- Coverage Validation
- Site Acceptance Guidelines
- RadioFrame System Functionality Test
- RadioFrame System iDEN Functionality Test
- Interconnect & Dispatch Setup & Voice Quality
- Packet Data Service Connection and Latency
- Short Message Service
- Handover and Cell Reselection
- Interconnect Connection Stability and SQE Performance
- Dispatch Connection Stability
- Idle SQE Testing and Validation
- System Self-Recovery Test
- Packet Data Stability and Throughput
- Validation of ‘Unable to Key BR’ Alarm
- Rectifier & AC Power Alarms
- iSC-3 Functionality Test
- RadioFrame System iDEN Functionality Test
- Connecting the RFS to the Customer LAN
- Operations and Maintenance
- Appendixes
Method of Procedure
Operations and Maintenance
132 RFN_3.1 Beta
‘Unable to Key BR’ alarm severity Description
minor An iDEN RadioBlade or 802.11b RAP has failed.
major An RFU has failed.
critical A card in a chassis unit has failed (except for the RLIC,
which returns alarm information.)
7.5.3 System Manager Alarms
The first table below lists System Manager alarms that are sent to the OMC, the
OMC alarm message, and the severity of the alarm. The second table describes
all System Manager alarms, and what action is required, if any, to resolve the
problem.
OMC Alarm System Manager Alarm Severity
BOARD DISABLED PEER LOSS MINOR (RAP only)
BOARD DISABLED PEER LOSS CRITICAL
(any board except RAP)
EXCESS RESETS EXCESS RESETS CRITICAL
ENABLE WAIT BR ENABLE FAIL MINOR
NO SPAM IN APC APC NO SPAM CRITICAL
RADIO BLADE LOST IDENRB LOSS MINOR
RFU DISABLED LOST RFU MAJOR
Alarm Description Action
5MHz CLOCK RIC or RLIC temporarily lost the 1 PPS
reference.
No action required.
ALARMS CLEARED Alarm Manager was cleared using the Clear
Alarms button.
No action required.
APC NO SPAM There are more BRs than the current SPAM
resources can support.
Add more SPAMs as
required.
APC SLOT MISS Slot mismatch detected on APC or NPC.
Causes a slot sync procedure three times.
If the slot still is not found, generates the
alarm APC SYNC FAIL.
APC SYNC FAIL APC SLOT MISMATCH is not able to
recover after three attempts.
Causes a system reset.
ASSGN FAILURE More than three consecutive assignment
failures occurred on a BR without any
successful calls in between.
The BR is locked out.