Installation Guide
Table Of Contents
- Title
- Contents
- Introduction
- System Description
- Pre-Installation
- Receipt of Equipment
- Site Planning
- Main Rack and Supporting Hardware
- Remote ACUs
- RFUs
- RadioBlades
- RAPs
- URU
- Interconnecting Cabling
- Main Rack Configuration
- RF Planning
- Site Survey
- Alarm Configuration
- Tools Required
- Installation
- Equipment Commissioning
- iDEN Interface
- Power Plant
- RadioFrame System
- Coverage Validation
- Site Acceptance Guidelines
- RadioFrame System Functionality Test
- RadioFrame System iDEN Functionality Test
- Interconnect & Dispatch Setup & Voice Quality
- Packet Data Service Connection and Latency
- Short Message Service
- Handover and Cell Reselection
- Interconnect Connection Stability and SQE Performance
- Dispatch Connection Stability
- Idle SQE Testing and Validation
- System Self-Recovery Test
- Packet Data Stability and Throughput
- Validation of ‘Unable to Key BR’ Alarm
- Rectifier & AC Power Alarms
- iSC-3 Functionality Test
- RadioFrame System iDEN Functionality Test
- Connecting the RFS to the Customer LAN
- Operations and Maintenance
- Appendixes
Method of Procedure
Equipment Commissioning
88 RFN_3.1 Beta
3 For Building Address, enter up to 3,000 alphanumeric characters specifying
the location of the NCU.
You can describe the street address, mailing address, building, and other site
information, as well as the building floor, telco closet, and rack to indicate the
location of the unit.
4 Select Save Changes.
5.3.5 Configuring the ACUs
Configure each ACU as you would the NCU, by entering a device name and site
address information (see the following illustration). For each ACU, the System
Configuration page shows the RFUs connected to the ACU (by port) and which
ACU ports are dedicated to which sectors in the iDEN installation. Sector
information is provided to the RFS via the iSC-3 data fill.
1 Navigate to the page of the ACU you want to configure.
2 For Device Name, enter up to 60 alphanumeric characters to uniquely
identify the ACU.
3 For Building Address, enter up to 3,000 alphanumeric characters specifying
the location of the ACU.
You can describe the street address, mailing address, building, and other site
information, as well as the building floor, telco closet, and rack to indicate the
location of the ACU.
4 Select Save Changes or Clear to start over.