User's Manual

RadioFrame System Method of Procedure GSM/802.11b
Operations and Maintenance
90 RadioFrame Networks, Inc.
Indication Possible failure Corrective action
ACU, and plug it in again. Boot
up may take several minutes.
fan is not working
 Verify that the fan is
operational.
 If the fan is not working, unplug
the ACU and contact Customer
Support.
RJ45 port Link and
Activity LEDs are not lit,
or the Activity LED is not
blinking
connection is not being
made between RFS
components
 For the affected port, verify that
all cabling between
components is properly
connected.
7.3.1.3 RadioFrame Unit
During installation, ensure that the RFU is receiving power and connectivity from the ACU
before inserting RadioBlades into the RFU or placing the front cover on the RFU.
Warning!
Do not remove the protective cover from or insert a connector into the AUX port. This will
cause damage to the RFU, the ACU, or both.
The MAIN RJ45 port has two LEDs: Link (right) indicates Ethernet connectivity, and
Activity (left) blinks to indicate Ethernet activity between the RFU and the ACU. For all
other conditions, refer to the following table.
Indication Possible failure Corrective action
MAIN Port LEDs do not
light
connection is not being
made between the RFU
and the ACU
 Verify that all cabling between
the ACU and the RFU is
properly connected.
 Verify that the ACU is powered
on.
 Contact Customer Support.