User's Manual

GSM/802.11b RadioFrame System Method of Procedure
Connecting to the Customer LAN
RadioFrame Networks, Inc.
79
If WPA-PSK is enabled, enter the pre-shared key in the PSK Password box. This
password must also be given to the WLAN client as described in the WLAN client’s
documentation. Setup is now complete.
If WPA or 802.1x is enabled, configure the RADIUS server as described below.
6 For Reauthentication Period, enter the amount of time before reauthentication is
forced. Note, that if the value for the System Manager differs from the value set for
the RADIUS server, the System Manager is given priority.
7 For Server Name/IP, enter the name or IP address of the RADIUS server on the
network.
Configure up to three servers for authentication services, so the network can have
backup authenticators. If you set up more than one server for the same service, the
first server in the list will be the primary server for that service, and the others are
used in the order listed when the previous server times out.
NOTE: You cannot change the Server Type (RADIUS).
8 For Port, enter the port number the RADIUS server uses for authentication.
The default setting, 1812, is the port setting for Microsoft's RADIUS server.
9 For Shared Secret, enter the shared secret used by your RADIUS server.
The shared secret on the iRAPs must match the shared secret on the RADIUS
server.
10 For Timeout, enter the number of seconds the iRAPs should wait before
authentication fails. If the server does not respond within this time, the iRAP tries to
contact the next authentication server in the list, if one is specified. Other backup
servers are used in the order listed when the previous server times out.
11 Repeat Steps 7 through 10 for each RADIUS server in the network.
12 Select the Submit button to save your changes.
13 For Accounting: select enabled to turn on accounting for your wireless network.
14 For Update Interval, enter the number of minutes between accounting update
messages that the iRAP sends for each associated client device.
15 For Server Name/IP, enter the name or IP address of the server to which the iRAPs
send accounting data.
16 For Port, enter the communication port used by the iRAP and the server.
The default setting, 1813, is the correct setting for the RadioFrame System and the
iRAPs.
17 For Timeout, enter the number of seconds the iRAPs should wait for the server to
respond. If the server does not respond within this time, the iRAP tries to contact the
next accounting server in the list if one is specified. The iRAP uses backup servers in
list order when the previous server times out.
18 Repeat Steps 15 through 17 for each RADIUS server in the network that will receive
accounting information.
19 Select the Submit button to save your changes.