User's Manual

GSM/802.11b RadioFrame System Method of Procedure

Final Checkout

RadioFrame Networks, Inc.

• Rack position (BCUs and ACUs only)

• Card position (APCs and BPCs only)

• RFU location (including floor and sector)

• GSM RadioBlade and iRAP slot positions in RFU

• MAC Address

• IP Address

• Channel (RAPs only)

• Port connections between RFS components

5.5.3.2 Cabling Pathways

A schematic showing the route of each cable run at the site. For each cable run, list the

following:

• Cable length

• Cable type

• Connector types (both ends)

• Cable labeling completed per specs

• Port Connections

• Continuity test results

• Distance test results

5.5.3.3 Floor Plan/Site Drawing

Use a floor plan or site drawing to denote the location of the following on each floor of the

building:

• Main rack

• Remote ACUs, including power source

• RFUs

5.5.4 RadioFrame System Acceptance Test

During installation, each component of the RFS is verified for power and connectivity.

Assuming that each component (BCU, ACU, and RFU) has been properly installed and is

receiving power, double check that all Power, Status, Link and Activity LEDs throughout

the system are lit and are green. For any other condition on any system component or

connection, refer to section 7.3 Corrective Maintenance for troubleshooting procedures.