User's Manual

RadioFrame System Method of Procedure GSM/802.11b
Final Checkout
64 RadioFrame Networks, Inc.
2 The IP Address is assigned during the installation of the RFS. You don’t need to
change the value of this internal address.
3 For Building Address, enter up to 3,000 alphanumeric characters specifying the
location of the BCU.
You can describe the street address, mailing address, building, and other site
information, as well as the building floor, Telco closet, and rack to indicate the
location of the unit.
4 Select Save Changes.
5.2.2 Configuring the ACUs
Configure each ACU as you would the BCU. For each ACU, the System Configuration
page shows the RFUs connected to the ACU (by port) and which ACU ports are
dedicated to which sectors in the GSM installation.
1 Navigate to the page of the ACU you want to configure.
2 For Device Name, enter up to 60 alphanumeric characters to uniquely identify the
ACU.
3 For Building Address, enter up to 3,000 alphanumeric characters specifying the
location of the ACU.
You can describe the street address, mailing address, building, and other site
information, as well as the building floor, Telco closet, and rack to indicate the
location of the ACU.
4 Select Save Changes or Clear to start over.