User's Manual

GSM/802.11b RadioFrame System Method of Procedure
RadioFrame Networks, Inc. v
List of Figures
Figure 1 The RadioFrame System uses a ‘tree’-style architecture............................. 8
Figure 2 BCU functional diagram................................................................................ 9
Figure 3 ACU functional diagram.............................................................................. 10
Figure 4 GSM RadioBlade functional diagram. ........................................................ 11
Figure 5 integrated RadioFrame Access Point (RAP) functional diagram................ 11
Figure 6 RFS and customer LAN functional diagram. .............................................. 12
Figure 7 A typical high capacity (12 BR) RFS installed in a four-story office
building. ..................................................................................................... 14
Figure 8 A typical low capacity (4 BR) RadioFrame System installed in a four-
story office building..................................................................................... 15
Figure 9 RFUs are located throughout the building to provide coverage.................. 16
Figure 10 RadioBlades and iRAPs are inserted into the RFU so that the antennas
point straight down to the ground. .............................................................. 17
Figure 11 Telco (T1/E1) interface with the GSM/802.11b/g RFS. .............................. 28
Figure 12 T568B standard. ......................................................................................... 41
Figure 13 Mount the ACU only in an EIA-standard compliant 19” rack. ..................... 50
Figure 14 Connect Port 2 on the front of the ACU to the specified port (1-8) on the
back of the BCU, and connect RFUs to ports 1-8 on the back of the
ACU. ..................................................................................................... 51
Figure 15 A wall mount requires two screws to anchor the RFU................................ 52
Figure 16 Use the provided bracket when mounting an RFU on the ceiling,
ensuring that all bolts or screws penetrate wood........................................53
Figure 17 Connect the RFU to the ACU, then ensure that the RFU is receiving
power and connectivity from the ACU. ....................................................... 54
Figure 18 Slide each GSM RadioBlade into the specified slot in the RFU. ................ 55
Figure 19 T1/E1 interface cable configuration ............................................................ 56
Figure 20 Connect the specified port on the front of the BCU (port 2 through 7) to
the customer’s LAN. ................................................................................... 71
Figure 21 Replacing a board in a BCU or an ACU. .................................................... 91
Figure 22 Alarms are listed up to 400 at time and continue to scroll as events
occur. ..................................................................................................... 93
Figure 23 Mount the BCU only in an EIA-standard compliant 19” rack. ................... 106
Figure 24 Mount the ACU only in an EIA-standard compliant 19” rack. ................... 107