User's Manual

RadioFrame System Method of Procedure GSM/802.11b
Appendix E: Connecting to the RFS
112 RadioFrame Networks, Inc.
Appendix E Connecting to the RFS
To connect to the RFS, you need a workstation (a PC or laptop computer). This section
describes how to configure the workstation and connect it to the RFS.
Connect the Workstation to the NCU
1 Configure the IP address of the workstation’s (PC or laptop computer) Ethernet port
as 192.168.200.4, and the subnet mask to 255.255.255.0.
2 Connect an Ethernet cable from the workstation Ethernet port to the NCU RLIC using
Ethernet port 2-7 (do not use Port 1, which is configured for iSC communications, or
Port 8, which is reserved for maintenance purposes).
3 Connect a serial cable between the PC serial port and the DB9 connector on the
NCU CRIC.
4 Start a HyperTerm session on the PC (or an equivalent terminal emulation program,
such as TeraTerm or Procomm).
5 For Name, enter a name for the connection, and then select OK (see the following
illustration).