User Manual

1-2
DrillTrack G2 System Overview
Features of DrillTrack G2 Receiver and DataView.
The DrillTrack G2 Receiver has been developed with the needs of the operator as the main priority.
Providing essential information automatically makes the equipment very easy to use and allows the
operator to work with confidence.
Once drilling has started the operation is fully automatic and the large LCD shows the operator
information about the drillhead.
The DrillTrack G2 Receiver LCD provides automatic walkover positioning of the drillhead.
Four arrows automatically direct the operator left/right and forward/backward.
When all four arrows are displayed the depth automatically appears on the screen and can be stored in
the integral Borelog.
The display also provides the operator with a Drill Heading (compass), Tilt angle (Inclination), Roll
Position and in the Manual Mode a Signal Strength reading (if selected in the user Setup).
Feature highlights include:
- Integral Borelogger
- Automatic tracking arrows that indicate Go... Left/Right/Forward/Backward.
- Drill head direction compass indicator.
- Interference rejection technology.
- Filtered rejection of standard line locator frequencies.
- No mis-locates due to ‘ghost signals’.
- No confusion caused by +/- locates.
- Down hole frequency change to overcome localised interference.
- Tilt angle compensated locate position and depth measurements.
- Automatic Depth readout.
- Metric or Imperial readout selection.
- Continuous display of Tilt angle and Roll.
- Tilt angle in % of Grade or degrees.
- Display Backlight.
- Comfortable working height to minimize fatigue.