User's Manual

ManualsBrandsRadiodetection ManualsElectronics20ft Vector Bar type 10/AA 2614

PDL-4 A.C.ID-M System (with GPS) User Guide

Page 20

If the tip of the SmartProbe-2 is outside the

Confirmation Zone, but not further than 4 ft from the

target cable, the 'Reposition the SmartProbe-2'

screen is displayed at one of two zoom levels

(maximum horizontal displacements of 2 ft or 4 ft).

'Position Estimate' is displayed across the screen.

If the probe tip is close to or within the Confirmation

Zone, and the A.C.ID-M signal is noisy, the

SmartProbe-2 will transmit an intermediate result and

continue measurement. The PDL-4 displays

'Rechecking A.C.ID-M' and a progress bar.

If the SmartProbe 2 has been placed too far away

from the target cable the “Cable out of range” screen

will be displayed indicating direction and approximate

position of the cable.

If the tip of the SmartProbe-2 is within the

confirmation box but at 180

to the cable the

PDL-4

display will show “Current Direction Wrong".

If A.C.ID-M confirmation is not achieved the PDL-4

will display a 'Not Confirmed'.

Penetration Bar

Assembly

Handle and Penetration Rod

Holding the Handle/Safety Lock assembly (1) with

the handle uppermost, ensure that the Safety Lock

(2) is turned fully anti-clockwise. This locks the

upper part of the rod to the handle.

Screw the Penetration Rod (3) to the Handle/Safety

Lock assembly and tighten using two

" AF

spanners.

Depth Indicator

Place the Outer Sleeve (4) on a hard surface with the

wider inner diameter uppermost then place the Disc

(5) on top of the Outer Sleeve. Press down firmly

and evenly on the Disc, forcing it to fit into the groove

around the Outer Sleeve.

With their wider ends uppermost, place the two

Collets (6) on the Penetration Bar and locate them in

the desired depth groove. Fit the 'O' ring (7) over the

Collets ensuring it is correctly seated in the grooves

provided.

With the Disc end uppermost, pass the Outer

Sleeve/Disc assembly up the Penetration Bar. Push

the Outer Sleeve/Disc assembly over the Collets/'O'

ring until the Disc end of the Outer Sleeve is flush

with the upper end of the Collets.

Operation

Safety Lock

To release the Safety Lock, rest the tip of the

Penetration Bar on the ground and, holding the

handle, rotate the Safety Lock

turn clockwise.