User Manual

Setting the Stimulation Level
To set the stimulation level, hold down the “Program” button. After a few seconds, the
receiver will indicate the present stimulation level by beeping a number of times
corresponding to the current level. For instance, for level 1, the receiver will beep one
time. For level 8, the receiver will beep eight times.
Continue to hold the “Program” button down until the number of beeps equals the level
of stimulation you want. After Level 8, the receiver will go back to Level 1.
Once the receiver has been programmed to the desired stimulation level, the receiver will
remember that level whether the unit has been turned off or with the batteries replaced.
Placing the Collar on Your pet
Keep everything except last statement.
Maintenance
Check batteries (weekly)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a practical installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Unauthorized changes or modifications to the equipment, not approved by PetSafe, could result in not meeting compliance
with FCC regulations and could void the user’s authority to operate the equipment.
Radio Systems Corporation, 10427 Electric Ave, Knoxville, TN 37932
1-800-732-2677 www.petsafe.net
Add picture of new transmitter