User Manual

Install Batteries
The transmitter takes one (1) 9-Volt Alkaline battery. To install, follow the instructions
listed below:
• Place your finger on top of the “Pull” area of the battery door, located on the backside
of the transmitter.
• Now remove the battery door by pulling your finger towards you.
• Insert the battery and replace the battery door.
The receiver takes two (2) 3-Volt Lithium batteries (Model 2032). To install, follow the
instructions listed below:
• With a Philips screwdriver, remove the two screws located on top of the receiver.
• Remove the battery door and insert the two batteries into the battery door as shown in
the drawing below.
• Insert battery door with batteries back into the receiver and secure it with the two
screws.
Turning the Deluxe Remote Trainer On/Off
To turn the receiver on, slowly connect the white dots located on both the receiver and
transmitter and separate. Upon separating, the receiver will emit one short beep.
Note: Once the receiver has been activated, the receiver must be manually turned off
by following the instructions shown below.
To turn the receiver off, slowly connect the white dots located on both the receiver and
transmitter, hold for three (3) seconds, and separate. Upon separating, the receiver will
emit a long beep indicating the unit has been turned off.
Add picture(s) of transmitters displaying each step.
Add same drawing that is for the Ultralight receiver in
the Owners guide for the fence system.
Add new pictures showing white dots.