User Manual

Deluxe Remote Trainer Owner’s Manual

Changes made to the old Remote Trainer Owner’s Manual for new manual

Front Page

Change picture to reflect dog with new receiver

Components

Add to the list of “Components” – receiver batteries, long probes

Add picture instead of drawing displaying the components

Assemble Collar

Change instructions to the following:

To assemble the collar, first measure your pet’s neck, mark the appropriate length, and

cut off any excess collar. Seal the edge of the cut by taking a match or lighter along the

frayed edge.

Note: When cutting off the excess collar, be sure to leave enough slack for your dog’s

growth.

When threading your collar through the clasp, loop it through the clasp exactly as

illustrated. Pull on the excess collar. If it slides at all, it was not looped correctly.

If your dog has long or thick hair, the longer probes might be more effective in delivering

the stimulation to your dog. If the dog still has trouble feeling the stimulation even with

the longer probes, the dog’s hair will need to be trimmed. This can be done either by a

veterinarian, or you can do it yourself.

Add new threading instructions

PAGE 1
Deluxe Remote Trainer Owner’s Manual Changes made to the old Remote Trainer Owner’s Manual for new manual Front Page Change picture to reflect dog with new receiver Components Add to the list of “Components” – receiver batteries, long probes Add picture instead of drawing displaying the components Assemble Collar Change instructions to the following: To assemble the collar, first measure your pet’s neck, mark the appropriate length, and cut off any excess collar.
PAGE 2
Install Batteries The transmitter takes one (1) 9-Volt Alkaline battery. To install, follow the instructions listed below: • Place your finger on top of the “Pull” area of the battery door, located on the backside of the transmitter. • Now remove the battery door by pulling your finger towards you. • Insert the battery and replace the battery door. Add picture(s) of transmitters displaying each step. The receiver takes two (2) 3-Volt Lithium batteries (Model 2032).
PAGE 3
Setting the Stimulation Level To set the stimulation level, hold down the “Program” button. After a few seconds, the receiver will indicate the present stimulation level by beeping a number of times corresponding to the current level. For instance, for level 1, the receiver will beep one time. For level 8, the receiver will beep eight times. Continue to hold the “Program” button down until the number of beeps equals the level of stimulation you want. After Level 8, the receiver will go back to Level 1.