Specifications

Mailing: PO Box 3526, Bellevue, WA 98009
Shipping: 13737 SE 26th St., Bellevue, WA 98005
Toll-Free: 800-259-7331 • Phone [phone] • Fax: [phone]
www.sgcworld.com • Email: [e-mail]
23
Attach the cable ties 2 inches from three ends of the pole. For the
fourth side (the bottom), place the cable ties 14 to 15 inches from the
end of the pole. This will create a 4 by 4 foot loop approximately.
Next, on the bottom below the cable ties, attach the coupler vertically
with rope or more cable ties.
Now, attach the antenna wire to the coupler output and loop the an-
tenna five times through the loops previously made. When completed,
attach the end of the loop antenna to the couplers ground terminal. If
any wire is left, pass it through an additional cable tie or just let it
hang from the lowest part of the loop. If the antenna ends up too short
to get to the ground terminal, remove it from the last cable tie and go
directly to the ground terminal.
SEARCH KIT Manual
page 23
Tuesday, March 26, 2002 13:21
Composite