Specifications

Mailing: PO Box 3526, Bellevue, WA 98009
Shipping: 13737 SE 26th St., Bellevue, WA 98005
Toll-Free: 800-259-7331 • Phone [phone] • Fax: [phone]
www.sgcworld.com • Email: [e-mail]
20
© March 2002 - SGC, Inc.
• Knot the ends of the supplied antenna wire together before at-
tempting to shape or install the antenna. Once the antenna has
been raised into position, the knot can be removed and the cou-
pler attached to the ends of the wire.
• Whenever nylon rope is cut, the ends will quickly become unrav-
eled. This can be eliminated by slowly warming the ends with a
small flame until the rope is melted slightly. You may use a
match or a lighter for this purpose.
• The coupler should be supported by a section of rope passed
through its mounting holes. Do not
allow it to hang unsupported
from the antenna wire.
• When the installation of STEALTH will be a two-turn or three-
turn configuration, forming the loops first will make the installa-
tion much easier to accomplish.
Appendix A (pg. 31) contains photographs of sample configurations
and performance test results.
For RF radiation
detection, the fluo-
rescent tube has
been moved
around the loop
until a position was
found where the
bulb glowed.
SEARCH KIT Manual
page 20
Tuesday, March 26, 2002 13:14
Composite