Specifications

Mailing: PO Box 3526, Bellevue, WA 98009
Shipping: 13737 SE 26th St., Bellevue, WA 98005
Toll-Free: 800-259-7331 • Phone [phone] • Fax: [phone]
www.sgcworld.com • Email: [e-mail]
17
• Attach the coupler to ends of antenna wire and lay it on the floor.
• Attach the cable from the coupler to the radio and connect the
coupler power leads - see section 4.4.
Do not coil any cables! Doing so can make them susceptible to the
radiated signal from the antenna and they can have a negative
effect on the performance of the antenna and radio system.
At this point in the construction of the antenna, which required 15
minutes to accomplish, emergency operation is possible.
When time permits, the installation should be completed to improve
the performance of the antenna by...
• Only in an emergency should coupler be hung by antenna wire. A
30 foot rope has been provided to support the coupler mechani-
cally and provide relief to the antenna wire. Attach a section of
rope through mounting holes on each side of the coupler.
The antenna has been
raised to its final posi-
tion and ends have
been connected to the
coupler which is lying
on the floor.
In this sample installation, the
support ropes were attached to
2 chairs.
SEARCH KIT Manual
page 17
Tuesday, March 26, 2002 13:14
Composite