Owner`s manual

8 WWW.SPORTDOG.COM
USE STANDBY MODE
The STEALTH™ Radio Locator has an automatic standby mode to conserve battery power for optimal
performance when in the field. In Standby Mode:
• The Power/Standby Indicator blinks at long intervals
• The location resets and the collar transmitter must be relocated
TO TURN ON STANDBY MODE:
Point the handheld receiver down toward the ground. The Power/Standby
Indicator blinks at long intervals.
TO TURN OFF STANDBY MODE:
Hold the handheld receiver horizontally. The Power/Standby Indicator
blinks at short intervals, and the receiver will begin to search for the
collar transmitter. Refer to the “Track Your Dog” section to find the
location of your dog (Step 5).
TO DISABLE AUTOMATIC STANDBY MODE:
1. Turn OFF the handheld receiver.
2. Turn ON the handheld receiver while pointing the handheld receiver down toward the ground. The
Power/Standby Indicator light blinks at long intervals.
TO ENABLE STANDBY MODE:
1. Turn OFF the handheld receiver.
2. Turn ON the handheld receiver while holding the handheld receiver horizontally. The Power/Standby
Indicator light blinks at short intervals, and the receiver will begin to search for the
collar transmitter.
CHANGE VOLUME SETTINGS
The handheld receiver provides several options using lights, sounds, and vibration when tracking your dog.
TO CHANGE VOLUME SETTINGS:
1. Press the Volume Button repeatedly to toggle through available settings, as follows:
Normal volume with vibrations (default setting)
Mute, lights only
Low volume
Normal volume, no vibration
Vibration only
STEP
::
07STEP
::
08
COPY COLLAR PAIRINGS TO OTHER RECEIVERS
The STEALTH™ Radio Locator allows you to share and track a collar with several receivers. Once the collar is
paired to a handheld receiver, you can copy that information to another handheld receiver.
Note: If the collar transmitter is turned OFF, the pairing information must be manually erased from the additional
receivers (see Step 10).
TO COPY COLLAR PAIRINGS BETWEEN HANDHELD RECEIVERS:
1. Hold a receiver in each hand.
2. Press the Transmitter Channel Button to select an available
channel number on the handheld receiver adding the collar.
The available transmitter number blinks.
3. Simultaneously press and hold the Copy Button on both
handheld receivers. The second receiver will start beeping
at one second intervals. The new channel number displays
on the second receiver indicating the collar pairing has been
copied successfully.
4. Repeat this procedure for each collar transmitter to be shared.
ERASE COLLAR PAIRING FROM THE HANDHELD RECIEVER
Erasing a collar transmitter erases the pairing information on the handheld receiver.
The collar transmitter cannot be tracked until it is paired again to a receiver. Be sure
you know the location of your dog or remove the collar transmitter from your dog
before erasing it.
TO ERASE A COLLAR TRANSMITTER FROM A RECEIVER:
1.
Press the Transmitter Channel Button to select the channel number that you want to erase from the
handheld receiver.
2. Press and hold the Transmitter Channel Button and the ON/OFF Button until you hear a series of
random beeps and the Signal Strength Indicator lights from bottom to top. The erased channel starts
to blink in the Transmitter Channel Display indicating that channel is now available for
pairing again.
RESET THE STEALTH
TM
RADIO LOCATOR
To completely reset the system to its default settings:
1. Remove the batteries from the collar transmitter.
2. Remove the battery from the handheld receiver.
3. Wait five minutes and reinstall the batteries in both devices.
STEP
::
09STEP
::
10