User's Manual

www.petsafe.net 7
Adjust the Pet Area to Desired Size
Make sure the entire Pet Area lies within your property boundaries (3A). Always
start determining the Boundary Zone at the shortest distance from Transmitter.
Place the Boundary Switch on “Low” if the Boundary Zone will be less than 45
feet from the Transmitter.
Make sure the Receiver Collar battery is properly installed, the Static Correction
level is set at 2 or greater, and the Test Light Contacts are touching the Contact
Points (3B).
Note: If your next-door neighbor has an In-Ground containment system, see
Troubleshooting section page 16.
Two-Person Method
Hold the Receiver Collar at your pet’s neck height (3C) with logo side facing away
from the Transmitter and Contact Points facing upwards. Walk to the edge of the
desired Pet Area. Facing away from the Transmitter, hold the Receiver Collar at the
edge of the desired Pet Area (3D).
Starting with the Boundary Control Dial set to “8”, have a second person turn the
dial down SLOWLY. When the Receiver Collar starts to beep, tell the person to stop
turning the Boundary Control Dial. Record your settings below for future reference.
Pet
Area
STREET
3A
3B
One-Person Method
Measure the shortest distance from the desired Boundary Zone to
the Transmitter. Find the distance on the Transmitter Range Chart
below and set the Boundary Switch and Boundary Control Dial.
Hold the Test Light Contacts to the Contact Points (3B). Take the
Receiver Collar to the Boundary Zone with the logo side facing
away from the Transmitter and Contact Points facing upwards
(3C). Hold the Receiver Collar at your pet’s neck level (3D) until
the Receiver Collar beeps and the Test Light fl ashes. If the Receiver
Collar beeps before or after the desired Boundary Zone, return to
3C
B
o
u
n
d
a
r
y
Z
o
n
e
Pet
Area
3D
the Transmitter and adjust the Boundary Control Dial. Repeat this process until the Receiver Collar is
beeping at the desired location. Record your settings below for future reference.
Transmitter
Range Chart
Boundary
Control
Dial
Position
Boundary
Switch
LOW
Boundary
Switch
HIGH
1
5-10 ft. 5-10 ft.
2
5-10 ft. 5-10 ft.
3
15-20 ft. 25-35 ft.
4
20-25 ft. 42-55 ft.
5
25-30 ft. 55-65 ft.
6
35-40 ft. 75-85 ft.
7
40-45 ft. 85-90 ft.
8
40-45 ft. 85-90 ft.
Note: These distances are approximate.
Record Your Settings
Final Boundary
Switch Setting
(HIGH or LOW)
Final Boundary
Control Dial
Position (1-8)
Receiver
Static
Correction
Level (1-6)
Home
Camping
Vacation
Other
Step
3