User's Manual

4 1-800-732-2677
Note: In many
neighborhoods,
nearby property lines
may limit how large
the Pet Area can be.
Maximum 90 ft. range
(45 average steps)
PET AREA
Transmitter
How the System Works
The PetSafe
®
Wireless Pet Containment System
®
has been proven safe, comfortable, and effective for pets over 8
pounds. The system works by transmitting a radio signal up to 90 feet in all directions. You temporarily defi ne the
Pet Area with Boundary Flags for a visual aid in training your pet. Your pet wears a Receiver Collar with Contact
Points that touch his neck, and, once trained, is allowed to roam freely in the Pet Area. When your pet reaches
the Boundary Zone, the Receiver Collar gives a warning beep before delivering a safe Static Correction through
the Contact Points to get his attention until he returns to the Pet Area.
Key Definitions
Transmitter: Transmits the radio signal and is the center of
the Pet Area.
Pet Area: Distance from the Transmitter where your pet can
roam freely.
Boundary Zone: 2 to 3 foot wide area outside the Pet Area
where your pet’s Receiver Collar will begin to beep and then
begin to deliver a Static Correction. The correction will start
in the Boundary Zone and continue anywhere beyond the Pet
Area. Note: The Receiver Collar is equipped with a safety time-out
feature that will stop correcting after 30 seconds if your pet remains
outside the Pet Area.
Receiver Collar: Receives the radio signal from the
Transmitter.
Correction Level Button: Adjusts the level of Static
Correction your pet receives outside the Pet Area.
Receiver Indicator Light: Indicates the level of correction at
which the Receiver Collar is set. This light also serves as a low
battery indicator.
Contact Points: Deliver the safe Static Correction when your
pet moves into the Boundary Zone.
Power Jack: Where the Power Adapter plugs into the
Transmitter. The Transmitter is powered by a standard 120-
volt outlet.
Boundary Switch: Adjust according to the size of the Pet
Area desired. Note: Adjusting the switch does not change the level
of Static Correction on the Receiver Collar.
Power Light: Indicates when the Transmitter is on.
Boundary Control Dial: Adjusts the distance from the
Transmitter to the Boundary Zone. Note: Adjusting the dial does
not change the level of Static Correction on the Receiver Collar.
Receiver Collar
Contact Points
Battery
Receiver
Indicator
Light
Washers
Correction
Level
Button
Transmitter
Boundary Switch
On/Off Switch
Power Jack
Power Light
Boundary Control Dial
H
A
P
P
Y
O
W
N
E
R
S
S
A
F
E
P
E
T
S