Product Manual

1-800-732-267710
Step 3: Adjust the Pet Area to Desired Size
Make sure the entire pet area lies within your property boundaries (3A). Always start determining the boundary zone at the shortest distance
from transmitter. Place the boundary switch on “–” if the boundary zone will be less than 45 feet from the transmitter.
Note: If your next-door neighbor has a containment system, see Troubleshooting section page 16.
Test Light Instructions
1. Make sure the receiver collar battery is properly installed.
2. Set the correction Level to 2 or above.
3. Hold the test light contacts to the contact points (3B).
4. Walk toward the boundary zone holding the receiver collar about waist high until the test light flashes (3C).
Save Test Light for future testing.
Note: If the test light does not flash, check the battery status by turning the receiver off, then on and verify the light is green. If the light is red
install a new battery and re-test. If test light still does not flash, contact the Customer Care Center.
To maximize your pet area, make sure the boundary switch is on “+” and the boundary control dial is set to “8”. Plug power adaptor into power
jack and standard 120 volt outlet. Turn the transmitter on.
Two-Person Method
Hold the receiver collar about waist high with logo side facing away from the transmitter and contact points facing upwards. Walk to the edge
of the desired pet area. Facing away from the transmitter, hold the receiver collar at the edge of the desired pet area (3C).
Starting with the boundary control dial set to “8”, have a second person turn the dial down SLOWLY. When the receiver collar tone starts, tell
the person to stop turning the boundary control dial. Walk back into the pet area until the receiver stops sounding. Verify the pet area boundary
by walking towards the boundary zone and verifying that the tone/test light flashes begin at the desired location. Test at multiple locations
around the pet area to verify the pet area is within your desired location. Record your settings on page 11 for future reference.
One-Person Method
Measure the shortest distance from the desired boundary zone to the transmitter. See the transmitter range chart on page 11 and set the
boundary switch and boundary control dial. Hold the test light contacts to the contact points (3B). Take the receiver collar to the boundary
zone with the logo side facing away from the transmitter and contact points facing upwards (3C). Hold the receiver collar about waist high until
the receiver collar tone sounds and the test light flashes. If the receiver collar tone sounds before or after the desired boundary zone, return to
the transmitter and adjust the boundary control dial. Repeat this process until the receiver collar tone sounds at the desired location. Record your
settings on page 11 for future reference.
Pet Area
Street
Pet
Area
B
o
u
n
d
a
r
y
Z
o
n
e
3A
3C3B