Operating instructions

Radio Systems Millenium-D Livewire Console
Page 14
Millenium - Livewire Console Software
Creating Backstreams (Mix-Minus feeds for 2-way devices)
Gaining Perspective
A Millenium output is a Source (input) to Livewire.
A Millenium input is a Destination (output) of Livewire.
Nomenclature assumes the Livewire network as the point of reference, so;
A Livewire Destination is an Input to the Millenium Console.
A Livewire Source is an output from the Millenium Console.
Connecting the Two-Way Devices
On the source node’s browser page, set a unique Axia channel number (for example, “1021”, where 102 is the last 3 digits
of the node’s IP address, and 1 represents the physical port into which the device is connected).
Dene the Source Properties in the Millenium Browser
Check all applicable boxes, including ENABLING the Backwards Feed check box.
Select Backstream Mode
In the Millenium browser Console Output section, set one of the outputs (from Outputs 3-8 - Outputs 1 and 2 are reserved)
in the Backstream (Mix-Minus) Stream Mode. Ensure that the faders chosen have source “1021” (for example) available
on the Source Prole Menu.
Connect the Two-Way Devices’ Input to a Destination Node
On the destination node’s browser page (ie. feeding the codec’s mix-minus), click on the Destination page, then change Type
to “To Source” on the channel whose physical destination is the codec’s mix-minus. Put “1021”(for example) in the
Channel Number eld.
Conrm Selection
As a visual verication, when the codec is selected on a Millenum fader, two dots will appear above the Destination
Node’s corresponding output channel.
Utility Bus Programming
Using the Millenium Console Utility Bus setup screen, create the appropriate mix minuses for Utility Bus 1-6.
Millenium console outputs (Sources to Livewire) are factory default congured as:
Livewire - Input #1 from Console Program Output*
Livewire - Input #2 from Console Audition Output*
Livewire - Input #3 from Console Utility Output #1*
Livewire - Input #4 from Console Utility Output #6*
Livewire - Input #5 from Console Utility Output #2*
Livewire - Input #6 from Console Utility Output #7*
Livewire - Input #7 from Console Utility Output #3*
Livewire - Input #8 from Console Utility Output #8**
Note: All outputs have been factory hard-wired between the console digital output board and Livewire input board as shown.
The 6 utility outputs have been factory congured as mix-minus outputs so that program is sent “minus” that channels
program audio is sent.
E.G. -Utility output #1 is congured to be program (A or B input / post on-off switch post fader / mono mix) minus the
program output of the rst Livewire fader.