Specifications

Using the Outdoor Antenna
7
100ft. CAT-5 Patch
cable to provide audio
and power. Enter via
waterproof grommet and
plug into provided RJ-45
connector inside lid.
For best performance,
attach a wire (not sup-
plied) from the Ground
Wire Connector on the
top of the ATU to a good
earth ground.*
Some examples of good
earth grounds are:
• The center screw that
holds the cover on a wall
electrical outlet.
• Plumbing and water
pipes (metal).
• A copper ground rod
driven into the earth.
Switch to Right
for DVR Playback
Switch to Left for
LIVE Broadcasting
Plug into
Headphone Jack
Optional
Mic Input
Thread 3 meter whip
antenna securely into
connector on top of
antenna enclosure
POWER
LED
+3V Power
to DVR
+18V Power
from Plug in
Power Supply
Mount the Outdoor Enclosure to a pole or top side of a building so that the antenna
is unobstructed and not near any trees or metal structures.
Connect the transmitter via the supplied CAT-5 patch cable.
CAUTION : DO NOT CONTACT ELECTRICAL OR HIGH TENSION WIRES WITH THE ANTENNA.
YOU CAN BE KILLED.
*Please note that Part 15 FCC regulations do not allow an antenna in excess of 3 meters in
length and usually the ground wire length is considered a part of this length and is added to
this total antenna measurement calculation.
Consult the DVR manual for recording and loop
playback. Note that the internal audio storage in the
transmitter is not available and the switch on the rear
of transmitter should be set to “LIVE” radio.