User's Manual

6 1-800-732-0144
Prepare the Collar Receiver
Inserting 3-Volt Batteries
1. Use a small Philips screwdriver to remove the two screws on the receiver.
2. Press the battery door up in the direction of the arrows on the door. It will move up
slightly and the door will release.
3. Insert two, 3-volt lithium CR2032 batteries per the diagram on the receiver.
4. Replace the battery door. Check to ensure the gasket is in place and clean.
5. Tighten the screws. Do not over tighten.
Press Door Up Pull Door Out Gasket
To Turn the Collar Receiver On:
1. Press and hold the On/Off Button until the
Receiver Indicator Light comes on
and the Collar Receiver beeps 5 times.
2. Release the On/Off Button.
The Receiver Indicator Light will fl ash until
the Collar Receiver is turned off. The fl ashing
light indicates the Collar Receiver is ready
to receive a radio signal from the Remote
Transmitter.
On/Off Button
To Turn the Collar Receiver Off:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Collar Receiver beeps 2 times.
2. Release the On/Off Button.
Important: If the Receiver Collar is left on continuously, the maximum battery
life (before replacing batteries) will be two weeks.
Receiver Indicator Light
Function Indicator Light Response
Collar Receiver on – good battery Flashes once per second
Collar Receiver on - low battery Flashes once every 4 seconds
Continuous Stimulation button pressed Solid in color
Tone Only button pressed No response
Step
2