Product Description

Invisible Fence
®
Brand
Boundary Plus
®
2.0 System
Field Test Plan
18 of 20
U:\My Documents\Invisible Fence\Field Testing\Boundary Plus 2.0\Pre-Pilot-1\191002co Boundary Plus 2_0 Field Test Plan.docx
Family, friends and staff members that can keep an eye on things are always the first choice. Ensure that
when performing tests, any pet at the test site is contained by some other means.
5.2.1 Initial Installation
An Installation Form will be completed on-site for each test location. Each test location will have (1) 4
Port Host transmitter, at least (1) Receiver, (2) 2 Port Host Shields
®
Wireless transmitters and (1) 2 Port
Host Shields Wired transmitter. More Shields units may be placed at one location. The objective is to get
all of the devices in the field. The 4 Port Host transmitter is designed to be installed with an LP4100 or
LP4200 surge protector. The following information will be documented while installing the test systems.
It is recommended all devices are configured in the office. Transmitter ranges should be set on-site and
receiver correction levels can be set on-site, if needed.
1) Testing information – Dealership, Person performing tests
2) Property info - Test site address, estimated loop wire
3) Receivers
a) Serial Number
b) Type of pet
c) Serial Number
d) Network and device ID
e) Frequency
f) Settings for each transmitter
4) Transmitters
a) Serial Number
b) Location
c) Serial Number
d) Network and device ID
e) Frequency
f) Final range setting
g) Transmit rate
5) Site check
a) Verify signal field/receiver activation
i) Activation: As expected?
ii) Delay: As expected?
iii) Time out: Approximately the timeout setting?
iv) Tone and Vibe: As expected?
v) Corrections: As expected?
vi) Document test locations
b) Verify activation near adjacent fields if available
c) 4 Port Host transmitter
i) Test Break-Alert
ii) Test BBU operation
d) Check site for signal bleeds