Product Description

Invisible Fence
®
Brand
Boundary Plus
®
2.0 System
Field Test Plan
15 of 20
U:\My Documents\Invisible Fence\Field Testing\Boundary Plus 2.0\Pre-Pilot-1\191002co Boundary Plus 2_0 Field Test Plan.docx
(1) Network ID: 010
(2) Field ID: 87
(3) Hub ID: 01 (Field ID for Shields
®
Wireless #1) - Select top Program button to view and
select settings.
(4) Frequency: 15000 - Select middle Program button to set frequency.
(5) Static Level, Static Interval, Delay, Tone, Vibe, Timeout: Your Choice – Different from
Receiver #1.
(6) Action: Avoid
(7) Mode: Traditional
ii) Program to interact with Shields Wireless transmitter #2
(1) Hub ID: 02 (Field ID for Shields Wireless #2) - Select top Program button to view and
select settings.
(2) Static Level, Static Interval, Delay, Tone, Vibe, Timeout: Your Choice – Different
(3) Action: Avoid
(4) Mode: Traditional
iii) Program to interact with Shields Wired transmitter
(1) Hub ID: 88 (Field ID for Shields Wired) - Select top Program button to view and select
settings.
(2) Static Level, Static Interval, Delay, Tone, Vibe, Timeout: Your Choice – Different
(3) Action: Avoid
(4) Mode: Traditional
iv) Program to interact with the 4 Port Host transmitter
(1) Hub ID: 96 (Field ID for 4 Port Host) - Select top Program button to view and select
settings.
(2) Static Level, Static Interval, Delay, Tone, Vibe, Timeout: Your Choice – Different
(3) Action: Avoid
(4) Mode: Boundary Plus
4) Tabletop Test – Ensure table is not metal or test is not completed on concrete floor with rebar
a) 4 Port Host transmitter (Loop wire connected, unit powered and BBU inserted)
i) Break-Alert Test
(1) Test 1
(a) Disconnect loop – Does Break-Alert LED and sound activate?
(b) Reconnect loop – Does Break-Alert LED and sound turn off?
(2) Test 2
(a) Disconnect loop – Does Break-Alert LED and sound activate?
(b) Press and release push button on front of lid – Does Break-Alert sound turn off?
(c) Reconnect loop – Does Break-Alert LED turn off?
ii) BBU Test
(1) Remove AC power – Does Logo flash?
(2) Replace AC power – Does Logo return to solid?
iii) Power Test – Complete with Receiver set to Traditional (#1)
(1) Find edge of signal field – Mark it
(2) Remove AC power – Does receiver activate at mark?
iv) Document all findings on Internal Test Form. Add detailed comments if needed.
b) 2 Port Host Shields Wireless transmitters (Powered with battery only)
NOTE: Shields unit push buttons are not “press and release.” They are “press, hold and release.” (i.e.
Press the button, hold until the display changes, release the button)