Product Description

Invisible Fence
®
Brand
Boundary Plus
®
2.0 System
Field Test Plan
14 of 20
U:\My Documents\Invisible Fence\Field Testing\Boundary Plus 2.0\Pre-Pilot-1\191002co Boundary Plus 2_0 Field Test Plan.docx
(3) Frequency: 15000
(4) Range: 456 (Range can be adjusted on unit)
(5) TX Rate: 8
(6) Slave Mode Flag: MODE_NORMAL
d) 2 Port Host Shields
®
Wired transmitter
i) Attach loop wire to the underside of device. (2) #6-32 screws are required. These can be taken
from an Indoor Shields Plus transmitter. If no screws are available, correction posts can be
used.
ii) Program
(1) Network ID: 010
(2) Field ID: 64
(3) Frequency: 15000
(4) Range: 456 (Range can be adjusted on unit)
(5) TX Rate: 3
(6) Slave Mode Flag: MODE_NORMAL
e) Receiver #1
NOTE: Set all corrections to levels you are willing to feel.
i) Program to interact with Shields Wireless transmitter #1 (Section 4.3.1).
(1) Network ID: 010
(2) Field ID: 63
(3) Hub ID: 01 (Field ID for Shields Wireless #1) - Select top Program button to view and
select settings.
(4) Frequency: 15000 - Select middle Program button to set frequency.
(5) Static Level, Static Interval, Delay, Tone, Vibe, Timeout: Your Choice
(6) Action: Avoid
(7) Mode: Traditional
ii) Program to interact with Shields Wireless transmitter #2
(1) Hub ID: 02 (Field ID for Shields Wireless #2) - Select top Program button to view and
select settings.
(2) Static Level, Static Interval, Delay, Tone, Vibe, Timeout: Your Choice – Different
(3) Action: Avoid
(4) Mode: Traditional
iii) Program to interact with Shields Wired transmitter
(1) Hub ID: 88 (Field ID for Shields Wired) - Select top Program button to view and select
settings.
(2) Static Level, Static Interval, Delay, Tone, Vibe, Timeout: Your Choice – Different
(3) Action: Avoid
(4) Mode: Traditional
iv) Program to interact with the 4 Port Host transmitter
(1) Hub ID: 96 (Field ID for 4 Port Host) - Select top Program button to view and select
settings.
(2) Static Level, Static Interval, Delay, Tone, Vibe, Timeout: Your Choice – Different
(3) Action: Avoid
(4) Mode: Traditional
f) Receiver #2
i) Program to interact with Shields Wireless transmitter #1 (Section 4.3.1).