User`s manual

2 How to use the Digital Camera
2.1 Installing Batteries
Slide the battery compartment cover in the direction of the
arrow to remove it.
Insert two AAA batteries according to the polarity symbols
marked inside. Replace the cover.
Note: When you use the USB cable to connect the camera
with a computer, it is unnecessary to use the batteries
because the camera can use the power provided by the
computer through the USB interface.
Warning:
- Dispose of old batteries promptly and properly.
- Do not burn or bury them.
- Use only fresh batteries of the required size and
recommended type.
- Power off the camera before removing the batteries. Do not
remove the batteries during use. Loss of power may cause
the photos to be deleted.
- If you do not plan to use the camera for a week or more,
remove the batteries. Batteries can leak chemicals that may
damage electronic parts.
2.2 Power On/Off
To turn on the camera, press Mode Button. “ ” and “ ”
appear on the LCD. Repeatedly press Mode Button (refer to
1.4 LCD Display) to select the desired mode/function. It will
automatically go back to normal Mode in 5 seconds if idle.
To turn off the camera, press Mode Button until “ ” appears,
and then press Snap Button within 5 seconds. This camera
can also automatically power off in 30 seconds if idle.
Note: The camera cannot be turned off when it is connected
to the computer via the USB cable.
- 4 -