Owner`s manual

System Requirements

To run Bedlam, you will need the following equipment:

Model I

• A Radio Shack 16K Level II TRS-80 Microcomputer

• A Radio Shack Cassette Recorder and Connecting Cable

Model III

• A Radio Shack 16K Model III TRS-80 Microcomputer

• A Radio Shack Cassette Recorder and Connecting Cable

Loading Instructions

Model I/III

It is assumed you have reviewed the general operational procedure for your

equipment as explained in your TRS-80 Owner's Manual, Computer Cassette

Recorder Manual, and the Cassette Information Sheet, which is enclosed with this

package. You should now be aware of how to turn on your computer and load tapes.

Note: If you are using a system with a disk drive, instructions are provided at the end

of this section for converting Bedlam to a disk file. To use Bedlam as a cassette

program, hold the BREAK key down while turning on the system.

Make sure your Bedlam cassette program tape is fully rewound and the "Play" key is

down on the recorder.

Turn on the system. If you are not familiar with the equipment, please refer to your

Owner's Manual.

The screen will show: You type:

Cass? (Model III only) Press [H]

Memory Size? Press [ENTER]

READY

>_ [S][Y][S][T][E][M] and press

[ENTER]

*?_ [B][E][D][L][A][M] and

press [ENTER]

After the program loads*, the screen will show: *?_. Type [\/\] and press

[ENTER].